Configuration; Logging On Using The Display Panel; Setting The Time Using The Display Panel - VESDA VLQ-100 Product Manual

Vlq series

Table of Contents

VESDA by Xtralis

Configuration

The VESDA VLQ detector is configured using the Xtralis QSC software or onboard DIP switches.

5.1

Prior to configuring or operating the detector using the display panel controls, it is necessary to log in to the

detector.

To log out of the detector, use the same sequence. Once logged in, the detector shows "Ln" on the display.

Note:

When detector is logged-on from the front panel, it is not possible to log-on from Xtralis QSC, and

vice-versa.

5.2

It is possible to set the time by the detector control panel or the Xtralis QSC software.

Setting the time using Xtralis QSC

1. Log onto the detector.

2. Press the Set Time button.

3. The current Hour, Minute, Second, Year, Month and Day settings are displayed in a pop-up window. Edit

as required then confirm the changes.

Setting the time using the Control Panel

1. Log on to the detector. Refer to Section 5.1 for further information.

2. Press and hold the Reset and Normalize buttons simultaneously for 5 seconds.

3. Set the hour by pressing the Test button to set the first digit, and the Disable button to set the second