Assemble The Fuselage; Mount The Wing; Mount The Stab & Fin - GREAT PLANES Electro Streak Instruction Manual

4. Glue the two aileron servo tray bases and the servo
tray in the center of the wing. Note: The two bases should
straddle the root ribs.

ASSEMBLE THE FUSELAGE

Mount the Wing

1. Inspect the blind nuts that are pressed into the bottom
of the wing nut plate inside the fuselage. If the nuts are not
securely pressed into the plate, remove them. Apply a dab
of 30-minute epoxy to the flange around the blind nuts, then
reinsert them into the plate. Do not get any epoxy into the
threads. Use a 6-32 x 3/4" machine screw and a #6 washer
to draw the blind nut all the way up into the wood by
tightening the bolt to the top of the plate.
2. Remove the covering from over the two bolt holes at
the trailing edge of the wing.
3. Test fit the wing to the fuselage and bolt it into position
with two 6-32 x 3/4" machine screws and two #6 washers. If
necessary, enlarge or adjust the wing bolt holes in the wing
so the wing bolts will align with the blind nuts.
Mount the Stab & Fin
1. Fit the stab onto the fuselage. Center the trailing edge
of the stab on the aft end of the fuselage. A clothespin
placed over the stab and fuselage works great for holding
the stab in position.
2. Stick a T-pin into the center of the top of the wing, at
the leading edge. Tie a small loop in one end of a 36"
[914mm] piece of non-elastic string such as K&S #801
Kevlar thread (K+SR4575). Slip the loop in the string over
the T-pin.
9