Cornelius Granita Training Manual page 43

7. Pull the gear motor off of the auger drive shaft,
make sure you do not loose the slinger washer.
Note: When reinstalling the gear make sure the
wires are routed so they cannot get caught in
the condenser fan.
Grease the back evaporation support
when you install the gear motor.
© 2003, IMI Cornelius Inc.
FIGURE 64
Distributed By:
Commercial Refrigeration Service, Inc.
http://WWW.IceCubes.NET
http://WWW.JetsprayParts.COM
(623) 869-8881
(866) 423-6253
Auger
Drive Shaft
Slinger
Washer
Slinger
Washer
Auger
Drive
Shaft
Apply grease to this area when you
- 35 -
Ice Peak Training Manual
FIGURE 63
install the gear motor.
FIGURE 65
Publication Number: TP01057
Viscosity
Switch