Cornelius Granita Training Manual page 36

Ice Peak Training Manual
Product is leaking from the dis-
pensing valve
Product is flowing into drain tray
through drainage tube
The auger and/or the upper mix-
ing unit is not turning
The auger and/or the upper mix-
ing units are creating noises as
they rotate
There is no light in the merchan-
dising lid or rear merchandising
panel
The cover does not fit properly on
the bowl
"Filtr" or "Err" message appears
on the touchpad LED readout
Publication Number: TP01057
•
The dispensing valve has been
incompletely or incorrectly replaced
in its position
•
The free movement of the dispens-
ing valve is impeded
•
Dispensing valve o-rings are dam-
aged
•
The bell shaped "shaft" seal
between the front of the cylinder
and the auger hub has not been
reinstalled properly
•
The bell shaped "shaft" seal or the
spindle bushing seal is damaged or
worn
•
Auger not turned on
•
Some electrical connections are
not complete
•
The gear motor(s) are malfunction-
ing
•
The large red bowl seal is not in
position, causing the gear teeth not
to mesh
•
The product brix is incorrect
•
The bell shaped "shaft" seal has
been replaced without lubrication
or is damaged
•
The auger has been incompletely
or incorrectly reassembled (ie the
auger's gear pins are not properly
seated)
•
The light bulb is burnt out
•
The 5 Amp fuse between the trans-
former and the lamp is blown
•
The transformer is blown
•
The bowl is incorrectly positioned
(the lower, outside corner is not
over the lower, outside base piece)
• The filter is dirty and needs to
be cleaned
• The unit is positioned too close
to a wall or other object restrict-
ing air flow and causing the
machine to run at a higher tem-
perature
• The filter is not properly
installed
• The unit has been installed
near a heat source, such as a
coffee machine, ice maker or
cold beverage machine which
expels hot air from its vents,
causing the machine to run at a
high temperature. (Installation
near a heat source should be
avoid)
- 28 -
•
Reassemble and replace
•
Clean and lubricate the valve and
valve cylinder with the lubricant
provided with the machine
•
Replace the o-rings
•
Find the seal and put it back in
place
•
Replace the damaged/worn seal
and check the condition of the
driveshaft.
•
Turn auger on
•
Check the contacts and correct the
ones that are incomplete
•
Replace the gear motor(s)
•
Check and correct
•
Check the product brix and correct
•
Replace or Clean and lubricate
with the lubricant provided with the
machine
•
Check and correct
•
Replace (See "Changing the light
bulb" section in this manual)
•
Replace
•
Replace
•
Remove bowl and position properly
• Clean and replace filter follow-
ing instructions (Removing and
Cleaning Filter)
• Reposition unit to maximize
ventilation space (see installa-
tion figures)
• Properly install filter see
"Removing and cleaning filter"
• Reposition unit to maximize
ventilation space (see installa-
tion figures)
© 2003, IMI Cornelius Inc.