Atlona AT-UHD-SW-52 User Manual page 7

TCP/IP
For convenience, the UHD-SW comes with DHCP on. This enables the switcher to be connected
to a network without knowing available IP addresses. If your network does not allow dynamic IP
addresses or if you are using the UHD-SW with a TCP/IP control system, this feature may be turned
off and the IP address set using RS-232 commands or the webGUI.
TCP/IP WebGUI
Atlona has created an easy to use WebGUI for initial setup and later changes to the configuration
of the UHD-SW.
To begin, plug a LAN cable into the LAN port of the UHD-SW and your network, then type the IP
address of the UHD-SW into a web browser of a PC connected to the same network
To find the switcher IP: use RS-232 command "IPCFG".
Note: IP addresses may also be found using common free IP scanner software such as "Advanced IP
Scanner"
Important: If any stability issues are experienced, disable any anti-virus or firewall that may interfere with
network communication to the switcher. Once set up is done and the switcher GUI is no
longer used, the firewall and anti-virus can be re-enabled.
A login screen will appear (this is the same log in for admin and general users). For the first log in
(and future admin changes) the username is "root" and password is "Atlona".
Note: Only the admin password can be changed (see page 9). The username will always remain
"root".
atlona.com
7
.
(as seen below)
Toll free: 1-877-536-3976
Local: 1-408-962-0515