Atlona AT-UHD-SW-52 User Manual page 14

Commands
The command codes are case sensitive, do not change capitalization, spacing, or lettering.
Command
PWON
PWOFF
PWSTA
VersionX
Ex. Version OSD
Type
REBOOT
Mreset
Lock
Unlock
x3AVx1
Status
x1$ X
AutoSW X
IRON
IROFF
EDIDCopyX memY
Ex. EDIDCopy1 mem2
EDIDMSetX default
EDIDMSetX saveY
EDIDMSetX intY
HDCPSetX Y
Ex. HDCPSet1 on
Each command or feedback is terminated with a carriage return.
Note: If the command fails or is incorrect the feedback is "Command FAILED"
[Y] preferred timing -
STD Sink (pass through)
3
1080P DD
6
1080P 3D DD
9
1280x800 2Ch
12
1280x800 DVI
Note: Preferred timings include audio EDIDs as well. 2Ch is two channel audio, MCh is multi-channel audio
(including up to Dolby TrueHD or DTS-HD Master Audio), DD is Dolby Digital, and DVI does not
include audio.
atlona.com
Feedback Description
PWON Turns switcher on
PWOFF Turns switcher off
PWSTA Displays power status
VersionX Displays the software versions: ex. VersionMCU
Ex. Version x.x.xx firmware [MCU]
OSD menu [OSD]
DSP [DSP]
FPGA [FPGA]
AT-UHD-SW-51 Displays the model information
REBOOT Reboots the AT-UHD-SW-52
Mreset Reset device to manufacture default
Lock Locks the front panel buttons
Unlock Unlocks the front panel buttons
x3AVx1 Switch inputs Ex. Switch output 2 to input 4= x4AVx2
x2AVx1, x3AVx2 Displays what input is connected to the what output
x1$ on Turns on/off output channel (X= on, off, sta)
Ex. x2$ off - Turns output 2 off
AutoSW on Turns auto switching on/off (X= on, off, sta)
IRON Turns on the IR receiver window
IROFF Turns off the IR receiver window
EDIDCopyX memY Save the EDID of output X (1 or 2) to memory Y (1-8)
Ex. EDIDCopy1 mem2 Ex. Copy EDID of output 2 to memory 5 = EDIDCopy2 mem5
EDIDMSetX default Set the EDID of the input to the default EDID
EDIDMSetX saveY Set the EDID of an input to the previously saved EDID memory
Ex. EDIDMset3 save1 - sets input 3 to EDID memory 1
EDIDMSetX intY Sets the EDID of an input to one of the internal EDIDs
Ex. EDIDMSet2 int3 - Sets input 3 to internal EDID 3
HDCPSetX Y Set HDCP reporting mode of the HDMI input (X= 1-5)(Y= on, off, sta)
Ex. HDCPSet1 on Ex. Input 3 to report HDCP non-compliant = HDCPSet3 off
1
1080P 2Ch
4
1080P 3D 2Ch
7
720P 2CH
10
1366x768 2Ch
13
3840x2160 2Ch
2
1080P MCh
5
1080P 3D MCh
8
720P DD
11
1080P DVI
14
3840x2160 MCh
14
Toll free: 1-877-536-3976
Local: 1-408-962-0515