Polycom Installation - Revolabs Fusion Setup Manual

Set-Up Guide
Polycom® Installation (Polycom VSX7000 shown for example)
This information is meant to be illustrative only. Consult your Polycom
Videoconferencing System Administrator Manual for specific instructions.
Step 1
1. Plug the red RCA connector on one end of Cable C into Polycom video-
station <Audio Out 1>, and then plug the red RCA connector on the other
end into the Fusion Base Station <Conf In>.
2. Plug the black RCA connector on one end of Cable C into Polycom video-
station <Audio In>, and then plug the black RCA connector on the other end
into the Fusion Base Station <Conf Out>.
To configure the Polycom system:
Select the button from the main screen to access the System menu.
Select the System / Admin settings.
Enter the administrator password and press OK (if needed).
Select the Audio settings.
Confirm or modify the following settings:

Midrange Speaker - OFF

Line Input – Audio Mixer

Echo Canceller - OFF

Line Output – Monitor Far Site Audio

Press OK to save changes.
Page 12
Step 2