Buttons And Controls - FLIR Scout Bi-Ocular Operator's Manual

Scout Bi-Ocular Operator's Manual
3–6
Power Button
Changing between the Off, On, and Standby power states is
controlled by the Power button. The table below describes
how the camera moves between states.
From
State
Off
On
Standby On
On
Standby Off
To shut off the camera completely press and hold the Power button
for eight seconds.
After holding the Power button for three
seconds this message will be shown in
the display and the camera will enter the
Off state if the countdown finishes.
Release the Power button at any time during this countdown to
terminate Shutdown and resume normal operation.
In the unlikely event of a large Electrostatic Discharge (ESD) to the camera it is
possible for the camera system to lose video or become frozen. If this occurs,
the following recovery sequence should restore the video:
• Hold down the power button for fifteen seconds and then release.
• Wait for five to ten seconds.
• Press the power button again. The camera should begin its bootup sequence.
431-BTS0-00-10, Revision 110
Quality FLIR Products Online at:

Buttons and Controls

To
State
On Press the Power button for 1 second. (This will put the
camera in power-on bootup for about 90 seconds
before going to On.)
Standby Momentarily press the Power button
Momentarily press the Power button
Off Press and hold the Power button for 8 seconds
Press and hold the Power button for 8 seconds
ESD Recovery Sequence
GlobalTestSupply
www.
3—Operating Your Camera
Method
.com
sales@GlobalTestSupply.com
15