Auto-Standby Operation - FLIR Scout Bi-Ocular Operator's Manual

Scout Bi-Ocular Operator's Manual
3–9
Auto-Standby is a feature of the Scout Bi-Ocular camera that helps to
guard against draining the batteries prematurely by inadvertently
leaving the camera on. Auto-Standby puts the camera into the
Standby state if the following three conditions are met:
• The camera is in the On state.
• The Auto-Standby switch (STBY) is set to ON.
• No buttons have been pressed for three minutes.
Once these conditions are met you will
see the following message in the display
and the camera will enter the Standby
state after the countdown is finished:
Press any button during this countdown to terminate Auto-Standby
and resume normal operation.
Note
Pressing any button during an Auto-Standby countdown will only
terminate the countdown and abort the Auto-Standby.
The normal function of the button will not occur.
Auto-Standby Switch
Unattended operation of the camera
requires disabling Auto-Standby.
Select OFF to turn off Auto-Standby.
Select ON to turn on Auto-Standby.
431-BTS0-00-10, Revision 110
Quality FLIR Products Online at:

Auto-Standby Operation

If Auto-Standby
is off, a reminder message will appear in the
display each time the camera enters the On state.
GlobalTestSupply
www.
3—Operating Your Camera
.com
sales@GlobalTestSupply.com
23