Table of Contents
Advertisement
Rectifying faults
Vent coolant circuit
7.4
Vent coolant circuit
If there is less coolant in the coolant tank than the minimum required you may need to
vent the coolant circuit. In this case the welding machine will automatically shut down
the coolant pump and signal an error, see chapter "Rectifying faults".
To vent the cooling system always use the blue coolant connection, which is located as
deep as possible inside the system (close to the coolant tank)!
60
NOTE
099-005224-EW501
08.11.2011
Advertisement
Table of Contents
Need help?
Do you have a question about the Wega 401 M1.02 FKG and is the answer not in the manual?