Maintenance; Spray Bottle Operating Procedure - Blodgett BCS-8E Owner's Manual

1. Unscrew the sprayer head and fill the con
tainer to the MAX mark. Screw the head as
sembly on firmly to ensure an airtight seal.
The liquid must be clean and free from for
eign matter. Do not overfill space must be
left for compressing air.
2. To build up pressure, pump approximately
20 full strokes when the container is filled
with liquid. The higher the pressure, the finer
the spray. If the container is only partially
filled, then more pumping is required to
compress the additional air space.
3. To spray, depress the trigger with your
thumb.
4. After a period of spraying, the pressure will
drop. Restore the pressure by operating the
air pump.
PROTECTIVE CLOTHING AND EYEWEAR SHOULD BE WORN
Pressure Pump
Spray
Head
Pump
MAX
Pressure
Vessel
NOTE: Clean the pump 2 or 3 times
per week with warm water
WARNING!
WHILE USING CLEANING AGENTS
15

Spray Bottle Operating Procedure

5. Release pressure after use by inverting the
spray head and depressing the trigger or by
slowly unscrewing the spray head assem
bly which will allow air to escape from
around the filling aperture.
6. After use, rinse the spray bottle with clean
water and check that the hole in the nozzle
is perfectly clean and clear. Warm water (not
hot) used with a household detergent is a
useful cleaning agent for this purpose.
NOTE: Further information can be found in
the instruction leaflet supplied with
your spray bottle.
Spray Trigger

Maintenance