Stacking Double Section Assembly - Blodgett BCS-8E Owner's Manual

Installation

Stacking Double Section Assembly

STACKING
1. Install 6" legs or casters on the bottom unit,
using three .50 13 UNC bolts provided per
leg or caster. If casters are used, ensure that
the casters with brakes are located on the
front of the steamer. See STEP 1.
Do Not Remove Body Top
2. Lift and mount the upper unit onto the lower
unit. Flush the edges on all four sides. Re
move the louvered panel and body back of
both units. Remove the lower body back
from the top unit. See STEP 2.
Remove
Body Back
Remove
Lower
Body Back
Remove
Body Back
3. Bolt the upper and lower units together with
the .50 13 UNC bolts provided. See STEP 3.
Bolt Through
Holes Closest to
Oven Center
STEP 3 (Rear of Units)
Caster
with Brakes
STEP 1
Remove
Louvered
Panel
and Save
Screws
STEP 2
PLUMBING
1. Attach copper Tee, gray hose and clamps to
the drain outlet of both units.
NOTE: The installation plumber is re
sponsible for connections be
tween units and connection to
drain. Use a 24" section on top
unit Tee to raise breather vent.
See STEP 4.
Breather Vent
Plumber Installed
Connection
24.00" Long
Tee, Hose
and Clamps
Plumber Installed
Connection
Tee, Hose
and Clamps
Plumber Installed
Connection To Drain
WARNING!
Improper installation, adjustment, al
teration service or maintenance can
cause property damage, injury or
death. Read the installation, opera
tion and maintenance instruction
thoroughly before installing or serv
icing this equipment.
10
STEP 4