Advertisement
Step 3.
Carefully move the surround into place.
Mark the positions of the bracket holes on the wall.
-
Move the surround aside and drill suitable sized holes. Insert the wall plugs* (D).
-
Place the surround into position and secure using two screws (E).
-
-
* ote: The wall plugs are only suitable for brick or block walls. For timber framed
walls covered in plaster board we recommend the use of heavy duty cavity fixings.
Step 4. Fitting the fire / heater.
For full fitting instructions see the installer and owner guide supplied with the fire /
heater. Please note that where applicable we do not recommend screw fitting the fire
/ heater to the Valor solo-pro back panel and hearth, but recommend the cable
retention method instead.
Caring for your Surround.
DO wipe any spills off immediately to limit possibility of staining.
DO clean regularly with a soft damp cloth.
-
DO NOT use abrasive cleaners.
-
DO NOT allow prolonged exposure to water.
-
-
©
GDC Group Ltd. 2013
INSTALLATION GUIDE
Page 6
Advertisement
