This guide is intended to help you install your surround. Please read carefully before installing. However, if further information is required, our Valor Fires Technical Helpline will be pleased to help. Telephone 0844 879 35 88 (National call rates apply in the United Kingdom) In the Republic of Ireland call 01 842 8222.
INSTALLATION GUIDE SAFETY When drilling into brick work always wear safety goggles, a dust mask, and always work in a well ventilated area. Keep children clear of work area. Always read the installer and owner guide supplied with the fire / heater. This guide should be read in conjunction with those supplied with the fire / heater.
Page 4
INSTALLATION GUIDE CONTENTS Figure 1. Contents (Items are not to scale. Any components extra to those above can be discarded). ASSEMBLING THE SURROUND The installation of this surround requires a reasonable level of DIY skills. Please read this guide thoroughly before commencing installation and if in doubt, seek help from a competent person Do I need any tools? You will need the following tools:...
Page 5
INSTALLATION GUIDE How to assemble the Surround. Step 1. Removing the gas rails for installations with electric heaters. For installations with electric heaters lay the surround (A) onto a smooth, flat, clean surface with the inside facing upward. Unscrew and remove the gas rails as in figure Figure 2.
Page 6
For full fitting instructions see the installer and owner guide supplied with the fire / heater. Please note that where applicable we do not recommend screw fitting the fire / heater to the Valor solo-pro back panel and hearth, but recommend the cable retention method instead.