System Update; Firmware Upgrade; Reboot System; Setting Management - Wirepath WPS-750-BUL-IPH Installation Manual

WPS-750-BUL-IPH Installation Manual

9.2.4. System Update

• Navigation: Log in as an administrator. From Home Screen, click "Config" button in top right corner, then click "User
Management" in left column "System" sub-menu.
Important! Updating Firmware MUST be performed over a wired IP connection to the device to ensure that a
connection is sustained throughout the process. If connection is lost during update, use the IP Installer to
find the device again and restart the update.
9.2.4.1.

Firmware Upgrade

See section 9.2.4.6. Upgrade the Firmware
1 Firmware
Current firmware version installed on the camera.
Version
New
Click "Browse" to search for a firmware file to upload from the PC to the camera.
Firmware
Click "Upgrade" (to the right) to upload the selected firmware in the "New Firmware" to the camera.
9.2.4.2.

Reboot System

Reboot the Camera. No settings are changed.
2
Click "Start" to reboot the camera.
9.2.4.3.

Setting Management

See sections 9.2.4.4. How to Back up Camera Settings
this feature.
Factory
3
Reset all settings to default. Click "Start" to begin the process.
Defaults
Load Settings
Click "Browse" to select a folder on the PC to load a camera backup file from.
From:
Apply Click the "Apply" button to load the backup file to the camera.
Remove (Guest Accounts only) Click to remove the user account.
26
1
2
3
for instructions on using this feature.
and 9.2.4.5. Load Backup Settings to the Camera for instructions on using