When Videos Cannot Be Viewed In 3D - NEC PH1202HL User Manual

When videos cannot be viewed in 3D

Please check the following points when videos cannot be viewed in 3D.
Please also read the operating manual attached to the 3D eyewear.
Possible reasons
The selected signal does not support 3D output.
The format for the selected signal is turned to [OFF(2D)].
A eyewear that is not supported by the projector is being used.
Please check the following points when a video cannot be viewed
in 3D using a 3D eyewear that is supported by the projector.
The power supply of the 3D eyewear is turned off.
The internal battery of the 3D eyewear is flat.
The viewer is located too far away from the screen.
Due to multiple 3D projectors working at the same time in the
vicinity, the projectors may interfere with one another. Alter-
natively, there may be a bright light source near the screen.
There is an obstacle between the optical receiver of the 3D eye-
wear and the 3D emitter.
The 3D format of the 3D video contents is not supported.
Solutions
Please change the video signal input to one that supports 3D.
Please change the format in the on-screen menu to [AUTO] or a
format that supports 3D.
Please purchase a commercially-available 3D eyewear or 3D emit-
ter (recommended). (→ page 40)
Please turn on the power supply of the 3D eyewear.
Please charge or replace the battery.
Please get closer to the screen until the video can be seen in 3D.
Please turn the L/R INVERT in the on-screen menu to [OFF].
Please maintain sufficient distance between the projectors.
Please keep the light source away from the screen.
Please turn the L/R INVERT in the on-screen menu to [OFF].
Please remove the obstacle.
Please check with the company selling the 3D video contents.
42
3. Convenient Features