Table of Contents
Advertisement
Turning On the Projector By Applying Computer Signal [AUTO POWER ON SELECT]
If set to [HDBaseT STANDBY], the projector automatically detects the synchronizing signal input from the following
selected terminals and projects the picture accordingly: Computer, HDMI, DisplayPort, HDBaseT, and SLOT.
OFF ........................ AUTO POWER ON SELECT function will be switch off.
HDMI, DisplayPort, COMPUTER, HDBaseT, SLOT
.............................. When a computer signal of a selected input terminal is detected, the power supply of the projector will be
turned on automatically and the computer screen will be projected.
NOTE:
• If you want to activate the AUTO POWER ON SELECT function after powering OFF the projector, interrupt the signal from the
input terminals or disconnect the computer cable from the projector and wait for at least 3 seconds before inputting the signal
from the selected terminal. When the projector is turned off and enters HDBaseT STANDBY mode, but signals from the computer
continue to be sent the projector, the projector maintains HDBaseT STANDBY mode and will not turn ON automatically. In addi-
tion, if signals from HDMI, DisplayPort or HDBaseT continue to be sent to the projector, depending on the settings of connected
external devices, the projector may turn ON automatically even if it is powered off and HDBaseT STANDBY mode is in effect.
• This function does not work when component signals come into COMPUTER IN terminal or when computer signals are Sync on
Green or Composite Sync.
Enabling Power Management [AUTO POWER OFF]
When this option is selected you can enable the projector to automatically turn off (at the selected time: 0:05, 0:10,
0:15, 0:20, 0:30, 1:00) if there is no signal received by any input or if no operation is performed.
NOTE:
• The power will not go off automatically when a signal from the Ethernet/HDBaseT port is being projected.
• [AUTO POWER OFF] appears in grey when the [STANDBY MODE] is set to [HDBaseT STANDBY] and [0:15] will be set automati-
cally.
Using Off Timer [OFF TIMER]
1. Select your desired time between 30 minutes and 16 hours: OFF, 0:30, 1:00, 2:00, 4:00, 8:00, 12:00, 16:00.
2. Press the ENTER button on the remote control.
3. The remaining time starts counting down.
4. The projector will turn off after the countdown is complete.
NOTE:
• To cancel the preset time, set [OFF] for the preset time or turn off the power.
• When the remaining time reaches 3 minutes before the projector is turned off, the [THE PROJECTOR WILL TURN OFF WITHIN 3
MINUTES] message will be displayed on the bottom of the screen.
Setting for the Optional Board [SLOT POWER]
When using the optional board installed in the slot, set the following options.
PROJECTOR ON .................This feature will turn on or off the power to the optional board.
PROJECTOR STANDBY .......This feature will automatically enable or disable the optional board installed in the slot
NOTE:
• In the below three conditions are satisfied, the standby mode will go into the sleep mode.
The optional board is connected
In HDBaseT standby
[PROJECTOR STANDY] for [SLOT POWER] is enable
OFF: Forcibly turn off the power to the optional board installed in the slot.
ON (Default): Turn on the power to the optional board installed in the slot.
when the projector is in standby.
DISABLE: Select this option to disable the optional board in the projector standby.
ENABLE (Default): Select this option to enable the optional board in the projector standby.
123
5. Using On-Screen Menu
Advertisement
Table of Contents
