Table of Contents
Advertisement
Design and manufacturing conditions for the projector stand
Please hire an installation service provider (for a fee) to design and manufacture a customized stand. Please ensure
that the design complies with the following conditions:
•
There is one intake vent on either side and one exhaust vent at the rear. These should remain unobstructed. Also,
secure enough space for easy filter cover removal for filter cleaning.
•
Remove the level adjusters or the projector handles in case these hit against the stand. For removing the level
adjuster, rotate the level adjuster itself, and for removing the handle, remove the handle fastening screws.
•
Fix the stand onto the ceiling mount screw holes (6 positions) on the projector bottom face.
Dimensions of screw hole: for M6 screw Maximum depth 10 mm (Calculate the bolt length depending on the stand
design)
•
Horizontal adjustment mechanism (for example, bolts and nuts in 4 places)
•
Make sure to design the stand not falling over easily.
Reference drawings
* Figure illustrating the dimensions and conditions (not actual design blueprint).
(Unit: mm)
Exhaust vent
CAUTION
•
When moving the projector, make sure you have at least four people. Attempting to move the projector alone
could result in back pain or other injuries.
6 - M6 bolt
150 150
300
[Side View]
141
6. Installation and Connections
Horizontal adjuster
[Front View]
Intake vent
Intake vent
Advertisement
Table of Contents
