Table of Contents
Advertisement
Videos
•
Wide range of input/output terminals (HDMI, DisplayPort, HDBaseT, BNC, etc.)
The projector is equipped with a variety of input/output terminals: HDMI, DisplayPort, HDBaseT, BNC (5-core),
computer (analog), etc.
The projector's HDMI input/output terminals and DisplayPort input terminal support HDCP.
HDBaseT, promoted and advanced by the HDBaseT Alliance, is a connection standard for home appliances.
•
Slot for optional board
This projector has a slot for optional boards (sold separately).
•
Simultaneous display of 2 images (PIP/PICTURE BY PICTURE)
Two images can be projected simultaneously with a single projector.
There are two types of layouts for the two images: "picture-in-picture" (PIP) in which a sub-picture is displayed
on the main picture, and "picture-by-picture" (PICTURE BY PICTURE) in which the main and sub pictures are
displayed next to each other.
•
Multi-screen projection using multiple projectors
This projector is equipped with multiple HDMI input & output terminals that can connect multiple projectors in a
daisy chain. A high quality picture is achieved by dividing and projecting high resolution videos among the various
projectors.
Furthermore, the boundaries of the screens are smoothed using an edge blending function.
•
Seamless switch function for smoother screen changes when switching the signal
When the input connector is switched, the image displayed before switching is held so that that the new image
can be switched to without a break due to absence of a signal.
•
Supports HDMI 3D format
This projector can be used to watch videos in 3D using commercially-available active shutter-type 3D eyewear
and 3D emitters that support Xpand 3D.
Network
•
Supported by wired LAN
HDBaseT/Ethernet Port Video can be transmitted from a computer equipped with a RF-45 port that is connected
to a wired LAN to the projector, and the projector can also be controlled from the computer.
•
CRESTRON ROOMVIEW compatible
This projector supports CRESTRON ROOMVIEW,allowing multiple devices connected to the network to be man-
aged from a computer or controller.
Energy-saving
•
"LIGHT MODE" for low power consumption and "Carbon Meter" display
The projector is equipped with an "LIGHT MODE" for reducing power consumption during use. Furthermore, the
power-saving effect when the LIGHT MODE is set is converted into the amount of reductions of CO
and this is indicated on the confirmation message displayed when the power is turned off and at "Information" on
the on-screen menu (CARBON METER).
3
1. Introduction
emissions
2
Advertisement
Table of Contents
