❸ Turning On The Projector - NEC PH1202HL User Manual

❸ Turning on the Projector
NOTE:
• The projector has two power switches: A main power switch and a POWER button (POWER ON and OFF on the remote control)
• Turning on the projector:
1. Press the main power switch to the ON position (I).
The projector will go into standby mode.
2. Press the POWER button .
The projector will become ready to use.
• Turning off the projector:
1. Press the POWER button.
The confirmation message will be displayed.
2. Press the POWER button again.
The projector will go into standby mode.
3. Press the main power switch to the OFF position (O).
The projector will be turned off.
1. Press the main power switch to the ON position ( I ).
The POWER indicator lights up red.*
* This indicates that the STANDBY mode is in [NORMAL]
setting.
(→ page 122, 175)
• The buzzer sound is released when [NOTIFICATION
SETTING] for [BUZZER] is ON.
WARNING
The projector produces a strong light. When turning on
the power, make sure no one within projection range is
looking at the lens.
NOTE:
• The [STANDBY MODE] setting will be disabled and the projector
will go into the sleep mode when the network service is utilized
or the projector receives HDBaseT signal. In the sleep mode, the
fans in the projector sometimes rotate for the purpose of interior
parts protection. Please refer to page 122 about the sleep mode.
15
2. Projecting an Image (Basic Operation)