Troubleshooting - Hand Held Products 4600g User Manual

To Replace the 4800i Interface Cable:
1. Turn the power to the host system
OFF.
2. Disconnect the imager's cable from
the terminal or computer.
3. Use a screwdriver to unscrew the cord
lock from the base of the imager.
4. Locate the small hole on the side of
the imager's handle. This is the cable
release.
5. Straighten one end of a paper clip.
6. Insert the end of the paper clip into the
small hole and press in. This
depresses the retention tab, releasing
the connector. Pull the connector out
while maintaining pressure on the
paper clip, then remove the paper clip.
7. Replace with the new cable.
Insert the connector into the opening
and press firmly. The connector is
keyed to go in only one way, and will click into place.
8. Screw the cord lock back in place over the cord.

Troubleshooting

The imager automatically performs self-tests whenever you turn it on. If your
imager is not functioning properly, review the following Troubleshooting Guide to
try to isolate the problem.
Is the power on? Is the red aiming illumination line on?
If the red aiming illumination line isn't illuminated, check that:
• The cable is connected properly.
• The host system power is on (if external power isn't used).
• The trigger works.
Is the imager having trouble reading your symbols?
If the imager isn't reading symbols well, check that the symbols:
• Aren't smeared, rough, scratched, or exhibiting voids.
• Aren't coated with frost or water droplets on the surface.
• Are enabled in the imager or in the decoder to which the imager connects.
4600g, 4600r, 4800i User's Guide
Cable
Release
Cord lock
14 - 3