Maintenance - MasterCraft 058-8489-4 Instruction Manual

21

Maintenance

MAINTENANCE
REQUIRED
General inspection
free movement
In depth inspection
-
Replace worn or
broken parts
Lubrication
• Lubrication: If the Air-powered 3-in-1 Nailer and
the compressor are not equipped with an in-line
lubrication system, place up to 6 drops of
pneumatic tool oil into the air inlet before each
work day or after every 2 hours of continuous use,
depending on the characteristics of the workpiece
and type of fasteners used.
• Air-operated tools must be inspected periodically and worn or broken parts must be replaced
in order to ensure that the tools are operating safely and efficiently.
DANGER!
Potential hazard that will result in serious injury or loss of life.
• Disconnect the tool from the air compressor before performing maintenance/
service, adjusting, clearing jams, reloading, and when it is not in use.
Repairs must be performed by a qualified service technician only. Failure to
comply will lead to serious injury, or loss of life.
DESCRIPTION
Trigger, spring,
-
safety mechanism
Worn or broken
parts
See below
AIR-POWERED 3-IN-1 NAILER 058-8489-4
MAXIMUM SERVICE INTERVAL
TOOLS OR
MATERIALS
Each use or
REQUIRED
every 2 hrs.
None X
Pneumatic tool
X
oil
As
Monthly
needed
X X
X
MC-588489-15