Air System - MasterCraft 058-8489-4 Instruction Manual

Wood density
3
≤0.6 g/cm
3
>0.6 g/cm

Air system

• Always use clean, dry, regulated, compressed air at 4.8 to 7 bar (70 to 100 psi).
• Do not exceed the maximum or minimum pressures. Operating the tool at an inappropriate
pressure (too low or too high) will cause excessive noise, rapid wear, or misfiring.
WARNING!
Potential hazard that could result in serious injury or loss of life.
• Do not free-fire this tool at high pressure.
• Keep hands and other parts of the body away from the tool's discharge and
working areas when connecting the air supply. Failure to comply could lead
to serious injury or loss of life.
• It is recommended that a filter-regulator-lubricator be used and be located as close to the tool
as possible.
• If a filter-regulator-lubricator is not installed, place up to 6 drops of pneumatic tool oil into the
air inlet plug before each use.
Nail size
<1 1/4" (32 mm) brad nails
≥1 1/4" (32 mm) brad nails
<1" (25 mm) staples
≥1" (25 mm) staples
<1 1/4" (32 mm) T nails
≥1 1/4" (32 mm) T nails
<1 1/4" (32 mm) brad nails
≥1 1/4" (32 mm) brad nails
<1" (25 mm) staples
≥1" (25 mm) staples
<1 1/4" (32 mm) T nails
≥1 1/4" (32 mm) T nails
AIR-POWERED 3-IN-1 NAILER 058-8489-4
Compressor air pressure
70 psi
90 psi
70 psi
100 psi
70 psi
100 psi
90 psi
110 psi
90 psi
110 psi
90 psi
110 psi
12