Broil Element Does Not Heat - Electrolux 30" Service Manual

element or the wiring to the bake element is
defective. Go to step 2.
2. Remove the back from the range to gain access to
the terminals of the bake element. Program the oven
control for bake and measure the voltage drop across
the terminals of the bake element. If the meter reads
line to line voltage (240 VAC) the element is
defective. If the meter reads zero the wiring to the
element is open.

Broil element does not heat:

1. With the range connected to electrical power, go to
the back of the oven control and measure the voltage
drop between terminals BR and neutral with the
control not programmed (clock operating only). If
the meter reads line to neutral (120 VAC) the control
is defective. If the meter reads zero the broil element
or the wiring to the broil element is defective. Go to
step 2.
2. Remove the back from the range to gain access to
the terminals of the broil element. Program the oven
control for broil and measure the voltage drop across
the terminals of the broil element. If the meter reads
line to line voltage (240 VAC) the element is
defective. If the meter reads zero the wiring to the
element is open.
Oven door does not lock when the oven is pro-
grammed for clean:
1. Remove power from the range, go the back of the
control and disconnect the 15 pin plug. Measure the
resistance between pins 5 and 6 of the 15 pin plug
(in the plug). If the meter reads infinity, the lock
motor or the wiring to the lock motor is defective. If
the meter reads around 2400 ohms go to step 2.
2. Measure the resistance between pins 10 and 12 of
the 15 pin plug with the oven door closed. If the
meter reads infinity, the door switch or the wiring to
the door light switch is defective. If the meter reads
zero go to step 3.
3. Measure the resistance between pins 10 and 13 of
the 15 pin plug. If the meter reads infinity the lock
switch or the wiring to the lock switch is defective. If
the meter reads zero the control is defective.
Oven door locks but the oven does not heat:
1. If the oven operates in normal bake, program the
oven for clean and allow the door to lock.
Disconnect the 15 pin plug from the oven control
and measure the resistance between pins 10 and
11 in the plug. If the meter reads infinity the latch
switch or the wiring to the latch is defective. If the
meter reads zero the control is defective.
Door latch is partly closed with door open:
1. Program the oven for self-clean, remove the
right-hand bodyside, and hold the door switch
closed for 30 seconds. Touch cancel and hold door
switch in for 30 seconds. The lock motor should
lock and unlock the door.
69