Brow Streaks And Specks On Ceramic Glass Cooktop Surface; Areas Of Discoloration On Ceramic Glass Cooktop Surface; Appliance Not Level; Poor Baking Results - Electrolux E36GF76PPS Use & Care Manual

34
Solutions to Common Problems
bRoWn stReaks and sPecks on ceRaMic Glass cooktoP
suRface
• Boilovers have cooked onto surface. Use razor blade scraper to remove soil. See
instructions under General Care & Cleaning.
• Cleaning materials not recommended for ceramic-glass cooktop have been used. Use
recommended cleaners and cleaning method. See Ceramic-Glass Cooktop section in
this Owner's Guide.
aReas of discoloRation on ceRaMic Glass cooktoP
suRface
• Mineral deposits from water and food. Wet surface with water and sprinkle on a cooktop
cleaning creme. Scrub with a clean damp paper towel until the stain disappears. Wipe
remaining paste away, then apply a small amount of cooktop cleaning creme and polish
with a clean paper towel. Use cookware with clean, dry bottoms. See Ceramic-Glass
Cooktop section in this Owner's Guide.

aPPliance not level

• Place oven rack in center of oven. Place a level on the oven rack. Contact installing agent
if rack and cabinet cutout flooring are not level.
• Kitchen cabinet misalignment may make oven appear to be not level. Be sure cabinets
are square and level. Contact cabinet maker to correct problem.

PooR bakinG Results

• Many factors affect baking results. See Baking for hints, causes and corrections.

entiRe oven does not oPeRate

• When the unit is first plugged in, or when the power supply to the range has been interrupted,
the indicator lights will flash and the control will beep. To stop the lights from flashing, turn
the selector control knob to BAKE and back to OFF. The oven cannot be used until this step
is followed.
• Be sure electrical cord is securely connected into the electrical junction box.
• Cord/plug is not installed and/or connected. Cord is not supplied with oven. Contact a
qualified servicer.
• Service wiring not complete. Contact a qualified servicer.
• Power outage. Check house lights to be sure. Call your local electric company.
• Short in cord/plug. Replace cord/plug.
• Controls are not set properly. See instructions under Setting Oven Controls to set the
controls.
• House fuse has blown or circuit breaker has tripped immediately following installation. House
fuse may not be fully engaged. Check fuse and screw or engage circuit breaker securely.
• House fuse has blown or circuit breaker has tripped after the oven has been installed and
previously operating. Contact a qualified servicer.