Removing The Drawer Glide - Electrolux 30" Service Manual

Removing the drawer glide:

1. Each drawer glide is held to the drawer by one screw.
Remove the screw and lift the glide off.
One screw
Removing the drawer glide and rail on the chassis:
1. Remove the one screw holding the glide and rail in
the front and pull the rail forward.
One screw
Removing the large rear panel:
1. Disconnect power and remove the four screws
holding the panel to the rear of the range.
Four screws
Removing the lock motor assembly:
1. Disconnect power and remove the panel covering
the rear of the backguard and rear panel.
2. Mark and disconnect the wires from the lock motor
assembly.
3. Remove the two screws holding the lock motor
assembly to the rear of the range, then slide the
assembly back to release it from the lock rod.
Removing small rear panel:
1. Disconnect power and remove the fifteen screws
holding the panel to the rear of the range.
Removing the thermal circuit breaker:
1. Disconnect power and remove the small rear panel
and disconnect the wires from the circuit breaker.
135
Two screws
Fifteen screws