Leveling The Range - Electrolux 30" Service Manual

D. Connect neutral (white) wire of copper power
supply cord to center silver colored terminal
of terminal box, and connect the other wires
to outer terminals using the 3 loose nuts on
the terminal block to terminal box using 3/8"
nut driver or socket.
E. Reinstall terminal box cover.

8. Leveling the Range

Place a level on a properly installed oven rack.
Adjust the leveling legs under the bottom corners of
the range until the range is level.
9. Anti-Tip Bracket Installation Instructions
Before Starting - Tools You Will Need:
For leveling legs and Anti-Tip Bracket:
• Adjustable wrench or channel lock pliers
• 5/16" Nutdriver or Flat Head Screwdriver
• Electric Drill & 1/8" Diameter Drill Bit (MasonryDrill
Bit if installing in concrete)
For electrical supply connection:
• 1/4" & 3/8" Socket driver or Nutdriver
Additional Materials You Will Need
• Power Supply Cord or
• Copper Electrical Wiring & Metal Conduit (for hard
wiring)
Normal Installation Steps
1. Anti-Tip Bracket Installation Instructions
Important Safety Warning - To reduce the risk of
tipping of the range, the range must be secured to
the floor by properly installed anti-tip bracket and
screws packed with the range. Failure to install the
anti-tip bracket will allow the range to tip over if
excessive weight is placed on an open door or if a
child climbs upon it. Serious injury might result
from spilled hot liquids or from the range itself.
If range is ever moved to a different location, the
anti-tip brackets must also be moved and installed
with the range.
Instructions are provided for installation in wood or
cement fastened to either the floor or wall. When
installed to the wall, make sure that screws
completely penetrate dry wall and are secured in
wood or metal. When fastening to the floor or wall,
be sure that screws do not penetrate electrical
wiring or plumbing.
A. Locate the Bracket Using the Template -(Bracket
may be located on either the left or right side of the
range. Use the information below to locate the
bracket if template is not available). Mark the floor
or wall where left or right side of the range will be
located. If rear of range is against the wall or no
further than 1-1/4" from wall when installed, you may
use the wall or floor mount method. If molding is
installed and does not allow the bracket to fit flush
against the wall, remove molding or mount bracket
to the floor. For wall mount, locate the bracket by
placing the back edge of the template against the
rear wall and the side edge of template on the mark
made referencing the side of the range. Place
bracket on top of template and mark location of the
screw holes in wall. If rear of range is further than 1-
1/4" from the wall when installed, attach bracket to
the floor. For floor mount, locate the bracket by
placing back edge of the template where the rear of
the range will be located. Mark the location of the
screw holes shown in template.
20