To Cancel The Minute Timer Before The Set Time Has Run Out - Electrolux 30" Service Manual

Minute timer:
The minute timer serves as an extra timer in the kitchen
that will beep when the set time has run out. It does not
start or stop cooking. The minute timer can be used
during any of the other oven functions. The minute timer
can be set for any amount of time from 1 minute to 11
hours 59 minutes in the 12 or 24 hour modes.
To set the minute timer:
1. Press Timer On/Off , "0:00" and "TIMER"
will flash in the display.
2. Push the number pads to set the desired time in
the display. Press Start , the time will begin to count
down and "TIMER" will glow in the display.
Note: If Start is not pressed the timer will return to
the time of day.
3. When the set time has run out, "END" will show in
the display and beep 3 times, every 60 seconds,
until Timer On/Off is pressed.
To change the minute timer while it is in use:
1. Press Timer On/Off 2 times and enter the new
time using the number pads. Then press Start to
start with the new time.
To cancel the minute timer before the set time has
run out:
1. Press and hold Timer On/Off . The display will
return to the time of day.
Oven lockout feature:
The Oven Lockout feature prevents the oven from being
accidentally turned on. It does not disable the clock,
minute timer, surface elements or oven light switch.
To activate the oven lockout:
1. Press and hold Lock for three seconds.
2. After 3 seconds the lock icon light (
on and "DOOR LOCKED" will flash in the display.
Once the oven door is locked the "DOOR
LOCKED" indicator will quit flashing and remain
on along with the lock icon light.
To reactivate oven operation:
1. Press and hold Lock for three seconds. A beep
will sound and the lock icon light (
the time will be shown. The "DOOR LOCKED" will
continue to flash until the oven door has completely
unlocked.
2. The oven control may then be programmed for all
operations.
Temperature display - Fahrenheit or Celcius:
The oven control can be programmed to display tem-
peratures in Fahrenheit or Celsius. The range has been
preset at the factory to display in Fahrenheit.
To change the temperature from °F to °C or from
°C to °F:
1. Identify which display your control is set for now.
To tell if your range is set for Fahrenheit or Celsius
press Broil and hold for 7 seconds. A beep will
then sound. If "F" appears in the display it is set to
show temperatures in Fahrenheit. If "C" appears in
the display it is set to show temperatures in Cel-
sius.
2. Press Clean to toggle between the Fahrenheit to
Celsius display mode. The display will show either
"F" (Fig. 4) or "C".
3. Press Start to accept the change or press Clear
Off to reject the change.
Silent control operation:
The silent operation feature allows the control to be op-
erated without sounds or beeps whenever necessary. If
desired the control can be programmed for silent opera-
tion and later returned to operating with all the normal
sounds and beeps.
To change control from normal sound operation to
silent control operation:
1. Identify which sound operation your control is set
for now. To tell if your range is set for normal or
silent operation press and hold Stop Time for 7
seconds. "DELAY" will flash in the display. If ":SP"
) will come
appears, the control will operate with normal sounds
and beeps. If ":—" appears, the control is in the
silent operation mode.
2. Press Clean to toggle between the normal sound
operation and silent operation mode. The display
will show either ":SP" or ":—".
3. Press Start to accept the change or press Clear
Off to reject the change.
62
) will clear and