Removing The Drawer Glide - Electrolux 30" Service Manual

Removing the drawer glide:

1. Each drawer glide is held to the frame by two
screws. To remove a glide remove one screw in
front and one at the rear and lift the glide off.
Two screws
Warmer drawer area
Removing the warmer drawer:
1. The warmer drawer has two releases. The release
on the left side is visible and is released by pushing
up on the end.
Left side release
2. The release on the right side is hidden and is
released by inserting a small screwdriver above the
release and pushing down.
Release with a screwdriver
Removing the drawer seal:
Note: When the drawer is closed the seal will not touch
the front frame of the range so that the drawer
can vent.
1. The door seal is held to the inner drawer panel by
spring clips. To remove, pull seal away from the
panel.
Removing the outer drawer panel:
1. The outer panel is held to the inner panel by a lip at
the top and two screws at the bottom.
2. Remove the drawer from the range, remove the two
screws and lift up on the panel.
Removing the inner drawer panel:
1. The inner drawer panel is held to the drawer body by
seven screws. Two on each side and three across
the bottom.
115
Clip
Two screws