Cc 875 L Remote Controller; 875E Remote Controller; Preparation; Hard Wired - Marstair CC 875 Technical Manual

CC 875 L REMOTE CONTROLLER.

CC 875 L indoor units are supplied with a remote controller, wall mounting bracket
and two batteries.
The controller operates remotely by infrared signals and the bracket may be used
to park the controller for convenience.
Slide open the front cover: press down on
the top at the marked area and push off the
cover.
Insert the batteries ensuring correct
polarity. The display will blank and reset.
Replace the cover by sliding into position.
Operating instructions are on page 42.
--o--o--O--O--O--o--o--

875E REMOTE CONTROLLER.

875E units are supplied with a remote controller, wall mounting bracket, PP3 (9 volt) battery, screws and wall plugs.
The controller operates either remotely by infrared signals, when the wall mounting bracket may be used to park the
controller for convenience, or may be hard wired to the unit (via the wall mounting bracket) in applications where infrared
is inappropriate, e.g., high lighting level, no direct line of sight etc..

1. Preparation

Open the battery cover at the bottom rear of the
controller by sliding out and hinging up, push the
polarised connector onto the battery, slot into the
controller and close the cover. The controller is now
ready for operation as shown on page 44.
For convenience, the wall mounting bracket may be
secured to a wall and used to park the controller.

2. Hard wired

Use four core screened cable (available from TEV in 100m drums, part number 00526077).
The screen should be clamped to ground in the 875E unit but NOT connected at the wall bracket end.
NOTE: Great care should be taken to ensure that the wiring is correct, refer to the diagram and table below.
The cable should be connected prior to mounting the bracket, taking great care to ensure that the 4 contact
blades remain free to exert spring pressure on the handset terminals.
Secure the bracket to the wall by drilling two 6mm diameter holes in the positions shown, inserting the wall plugs
and securing with the two screws provided.
Attach the controller to the bracket ensuring that it is pushed down firmly.
If required, the controller may be locked into position by rotating the cam at the top of the bracket with a small
screwdriver. Operating instructions are on page 44.
The controller does not require a battery when this method is used.
Tel: 01823 665660
Heronhill - for all your Marstair requirements
--o--o--O--O--O--o--o--
www.heronhill.co.uk
24
Fax: 01823 665807