Remote Controller - Marstair ECO+ Installation & Owner's Manual

Remote Controller

How to insert batteries
(1) Remove the battery cover by sliding in the direction of the
arrow.
(2) Insert new batteries (2 x AAA) none rechargeable making sure
the polarity is correct
The remote controller will default to Heat Pump mode if no buttons
are pressed for 10 seconds, at which point the 'Heat'/'Cool' flashing
will stop.
Alternatively:
Press any button on the remote controller while "Heat" is
indicated to preset the controller for Heat Pump operation.
Notes:
If the remote controller is preset for cooling only, heating commands will
not be possible.
Refit the battery cover by sliding it back into position.
Storing the Remote Controller
The remote controller may be stored on a wall using the holder supplied.
Using the remote controller
To operate the Eco+ heat pump, point the controller at
the receiver in the middle of the unit.
The controller will operate up to 7m away from the unit
if pointed directly at the receiver.
4 /20
56208004-01