Cc875 E Remote Control Handset Operating Instructions; On/Standby; Starting The Unit; Stopping The Unit - Marstair CC 875 Technical Manual

CC875 E REMOTE CONTROL HANDSET OPERATING INSTRUCTIONS

Cool/Heat Modes (2.3):
D
Cooling only
F
Heating only
D F
Auto cool/heat
FAN
Fan only (2.1)
Set Back
8
High temp set
back (7.1)
9
Low temp set
back (7.2)
8
9
Both set back
Timer
No clock = No timer programme (6.2)

1 On/standby

1.1 Starting the unit:

Press the blue button once to illuminate the display.
Press the orange button
permanently on).

1.2 Stopping the unit:

Press the blue button once to illuminate the display.
Press the orange button (C) to switch the unit between 'on', (red LED on the unit permanently on), and 'standby', (red LED on the unit flashing at 5 second
intervals).
2 Basic Functions
2.1 To change the temperature setting (18EC to 28EC):
a. Illuminate the display (blue button).
Press TEMP EC button - the temperature digits will pulse.
b.
Press the + or - (• or – ) button, whilst pointing the handset towards the unit, (unless the handset is wire connected). Each
c.
press of the + or - (•/– ) button will increase/decrease the temperature setting by 1EC and transmit the new setting to the
unit. A single beep means the signal has been accepted.
NOTES:
Temperature settings cannot be changed if
FAN
to pulse (see 2.3).
Tel: 01823 665660
Heronhill - for all your Marstair requirements
Fan Speeds (2.2):
2
Low fan speed
3
High fan speed
4
Boost fan speed
2 3
Auto High
2 4
Auto Boost
Standby
C
Standby (1.2)
G
On (1.1)
Timer set (6.1)
Press the blue button once to illuminate the display.
To conserve battery power, the display will turn off after 1 minute if no button is
pressed.
Point the handset towards the unit when altering settings, unless the handset is
wire connected.
A single beep means a signal has been accepted.
(C)
to switch the unit between 'standby', (red LED on the unit flashing at 5 second intervals), and 'on', (red LED on the unit
FAN
is displayed; pressing the TEMP EC button in this state will cause the word
www.heronhill.co.uk
A
Transmit
Signal
Battery Indicator
B
Low battery power (9)
Set Temp/Functions
E
22 :
C Set temperature
18EC - 28EC (2.1)
:
SEt
Set day and time (3.1)
:
prog
Timer programme (4)
E""
: Incorrect input (4)
00:00
24 hour clock
(3.1, 4.1, 4.2)
:
FAN
Fan only (2.1)
--E :
C Set back function (7)
Days of the week (3.1, 4.1, 4.2)
Sunday to Saturday
• indicates day chosen
44
Fax: 01823 665807