Planet Networking & Communication WNRT-617 User Manual page 76

Incoming Protocol
Status
To add a new rule, follow the steps below.
Step 1. Click the Add New... button, the next screen will pop up as shown in
Select a common application from the Common Applications drop-down list, then the
Step 2.
Trigger Port field and the Incoming Ports field will be automatically filled. If the Common
Applications do not have the application you need, enter the Trigger Port and the
Incoming Ports manually.
Select the protocol used for Trigger Port from the Trigger Protocol drop-down list, either
Step 3.
TCP, UDP, or All.
Select the protocol used for Incoming Ports from the Incoming Protocol drop-down list,
Step 4.
either TCP or UDP, or All.
Step 5. Select Enable in Status field.
Step 6. Click the Save button to save the new rule.
The protocol used for Incoming Ports Range, either TCP or UDP, or ALL
(all protocols supported by the Router).
The status of this entry either Enabled or Disabled.
Table 5-25
Figure 5-27 Add or Modify a Triggering Entry
-69-
User's Manual of WNRT-617
Figure 5-27.