Planet Networking & Communication WNRT-617 User Manual page 73

Step 2. Select the service you want to use from the Common Service Port list. If the Common
Service Port list does not have the service that you want to use, type the number of the service
port or service port range in the Service Port box.
Step 3. Type the IP Address of the computer in the IP Address box.
Step 4. Select the protocol used for this application, either TCP or UDP, or All.
Step 5. Select the Enable check box to enable the virtual server.
Step 6. Click the Save button.
If your computer or server has more than one type of available service, please
select another service, and enter the same IP Address for that computer or
server.
To modify or delete an existing entry:
Step 1. Click the Modify in the entry you want to modify. If you want to delete the entry, click the
Delete.
Step 2. Modify the information.
Step 3. Click the Save button.
Click the Enable/ Disabled All button to make all entries enabled/ disabled.
Figure 5-25 Add or Modify a Virtual Server Entry
User's Manual of WNRT-617
-66-