Terbly Beam 2R User Manual page 23

remote control of devices connected to the DMX-bus. ANSI E1.20-2006 by ESTA specifies
the RDM standard as an extension of the DMX512 protocol.
Manual settings like adjusting the DMX starting address are no longer needed. This is
especially useful when the device is installed in a remote area.
RDM ready and conventional DMX devices can be operated in one DMX line. The RDM
protocol sends own packages in the DMX512 data feed and does not influence conventional
devices.
If DMX splitters are used and RDM control is to be used, these splitters must support RDM.
The number and type of RDM parameters depend on the RDM controller being used.
In general, the device supports the following commands and functions via RDM:
8.4.3 Display settings
Shut off time
With this function you can shut off the color LCD display after 2 to 59 minutes. Turn the
encoder in order to select the desired shut off time. The default is 5 minute.
Display Reverse
With this function you can rotate the display by 180°.
1．Tap <MODE/ESC>button，access the main menu，Tap the <Up/Down>button until
"Personality"is displayed. Press ENTER, the display will show "Personality". Tap the
<Up/Down>button until the display will show "Display Setting". Press ENTER, the
display will show "Display Setting".
2．Press <Up/Down>, the display will show "Display Reverse".
3．Press< ENTER>, the display will show "Display Reverse".
4．The display show "OFF",Press <Up/Down>, the display will show "ON".
5．Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
Key Lock
With this function you can activate the automatic keylock status. If this function is activated,
the keys will be locked automatically after exiting the edit mode for 15 seconds. keeping
press the<MODE/ESC> key for 3seconds if you do not need this function.
1．Tap <MODE/ESC>button，access the main menu，Tap the <Up/Down>button until
"Personality"is displayed. Press ENTER, the display will show "Personality". Tap the
<Up/Down>button until the display will show "Display Setting". Press ENTER, the
display will show "Display Setting".
2．Press <Up/Down>, the display will show "Key Lock".
3．Press< ENTER>, the display will show "Key Lock".
4．The display show "OFF",Press <Up/Down>, the display will show "ON".
- 22 - XM974-V1.0-NR