Terbly Beam 2R User Manual page 19

8.3.4 Lamp off via external controller
With this function you can select if you can switch the lamp off via an external controller
(DMX-channel of internal programs, value 224-239). Select "ON" by turning the encoder if you
wish to enable this function or "OFF" if you don't.
1．Tap <MODE/ESC>button， access the main menu， Tap the <Up/Down>button until"Lamp
Control"is displayed. Press ENTER, the display will show "Lamp Control". Tap the
<Up/Down>button until the display will show "Lamp Off Via DMX". Press ENTER, the
display will show "Lamp Off Via DMX".
2．Press <Up/Down>, the display will show "OFF"or"ON".
3．Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
8.3.5 Max on at temp.
With this function you can set the inside temperature from which the projector will restrike the
lamp after automatic lamp shut off.
1．Tap <MODE/ESC>button， access the main menu， Tap the <Up/Down>button until"Lamp
Control"is displayed. Press ENTER, the display will show "Lamp Control". Tap the
<Up/Down>button until the display will show "Max On at Temp". Press ENTER, the
display will show "Max On at Temp".
2．Press <Up/Down>, the display will show "45℃", Temperature generally in 20~79 ℃.
3．Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
8.3.6 Lamp off temp.
With this function you can set the inside temperature at which the projector will automatically
switch the lamp off.
1．Tap <MODE/ESC>button， access the main menu， Tap the <Up/Down>button until"Lamp
Control"is displayed. Press ENTER, the display will show "Lamp Control". Tap the
<Up/Down>button until the display will show "Lamp Off Temp". Press ENTER, the
display will show "Lamp Off Temp".
2．Press <Up/Down>, the display will show "130℃", Temperature generally in 80~139
℃.
3．Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
When the temperature around the lamp is higher than the preset value continuously up to
5 minutes, the lamp will be shut off automatically.
If the lamp be shut off automatically due to over heat, it can not be striked again
automatically, it must be turned on again by manually.
- 18 - XM974-V1.0-NR