Control Board - Terbly Beam 2R User Manual

In the case of the move head, which is a 12 channel fixture, you should set the starting address of
the first unit to 1, the second unit to 13 (12 + 1), the third to 25 (13 + 12), and so on.

8. Control Board

The Control Board offers several features: you can simply set the starting address , run the
pre-programmed program or make a reset.
The main menu is accessed by pressing the
Browse through the menu by pressing the
-button. Press the Enter-button in order to select the desired menu. You can change the
selection by pressing the the
Confirm every selection by pressing the
-button. The functions provided are described in the following sections. it will exit from
flash 10 seconds after the last keypress. Press this key under edit mode, . The functions provided
are described in the following sections.
To access the display menu via the internal battery, press the DC switch button for 2seconds;
To shut off the display immediately, choose the commend " Reset All" menu and press
"Enter" button, otherwise, the display will automatically switch off about 1 minute from
last button press.
Set Dmx Address
Dmx Value
Slave Mode
Auto Program
Sound Control
Time Information
Temperature Info
Software Version
-button ,
-button. You can leave every mode by pressing the
A001~AXXX
PAN......
Slave1,Slave2,Slave3
Master / Alone
Master / Alone
Current Time
Total Run Time
Last Run Time
Lamp Hours
Lamp Off Time
LastRun Password
Clean Last Run
LampTime Password
Clean Lamp Time
Head Temperature
V1.0......
- 10 -
-button until the display starts flashing.
-button , -button ,
-button , -button or
XXXX(Hours)
XXXX(Hours)
XXXX(Hours)
XXXX(Hours)
XXXX(Minute)
Password=XXX
ON/OFF
Password=XXX
ON/OFF
XXX /℉
-button or
-button.
DMX address setting
DMX value display
Slave setting
Auto program
Sound Control
Power on running time
Fixture running time
Fixture Last times clear
Lamp running time
Lamp off time
Timer Password 038
Clear Fixture Last time
Lamp Password ="038"
Clear lamp time
Temperature in the head
Software version
XM974-V1.0-NR