Terbly Beam 2R User Manual page 18

higher than the preset value, so even the lamp can not be striked even the menu Lamp is turned to
ON, as the lamp switch is compelled to turned off.
·When the temperature unit after the temperature value come to lowercase letter "c" or "f", it
means menu Lamp is turned to ON, but the lamp is not full dimming up.
·When the temperature unit after the temperature value come to capital letter "C" or "F", it menu
Lamp is turned to ON, and the lamp is full intensity.
8.3.1 Lamp on/off
With this function you can switch the lamp on or off via the Control Board.
1．Tap <MODE/ESC>button， access the main menu， Tap the <Up/Down>button until"Lamp
Control"is displayed. Press ENTER, the display will show "Lamp Control". Tap the
<Up/Down>button until the display will show "Lamp On or Off". Press ENTER, the
display will show "Lamp On or Off".
2．Press <Up/Down>, the display will show "OFF"or"ON".
3．Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
Remark: The menu Lamp On/Off is the software command only, the lamp can be striked
successfully only when the menu Lamp is set to ON and the actual temperature is lower than the
limited value.
8.3.2 Automatic on
With this function you can select if the lamp will be switched on when switching the power on.
Select "ON" by turning the encoder if you wish to enable this function or "OFF" if you don't.
1．Tap <MODE/ESC>button， access the main menu， Tap the <Up/Down>button until"Lamp
Control"is displayed. Press ENTER, the display will show "Lamp Control". Tap the
<Up/Down>button until the display will show "Automatic On". Press ENTER, the
display will show "Automatic On".
2．Press <Up/Down>, the display will show "OFF"or"ON".
3．Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
8.3.3 Lamp on via external controller
With this function you can select if you can switch the lamp on via an external controller
(DMX-channel of internal programs, value 64-79). Select "ON" by turning the encoder if you
wish to enable this function or "OFF" if you don't.
1．Tap <MODE/ESC>button， access the main menu， Tap the <Up/Down>button until"Lamp
Control"is displayed. Press ENTER, the display will show "Lamp Control". Tap the
<Up/Down>button until the display will show "Lamp On Via DMX". Press ENTER, the
display will show "Lamp On Via DMX".
2．Press <Up/Down>, the display will show "OFF"or"ON".
3．Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
- 17 - XM974-V1.0-NR