4062
Error
code or
message
203.01
203.08
203.10
203.18
2-28
Service Manual
Error contents
Internal duplex drive
motor control failure.
Internal duplex
Redrive motor load
error
Redrive motor control
failure.
Media tray 1
Redrive motor
assembly underspeed
error.
Description/Action
The internal duplex drive motor
motor does not reach the
proper operating speed at the
specified time.
The redrive motor assembly
has failed or caused high
mechanical load during the
warm up sequence.
The redrive motor does not
reach the proper operating
speed at the specified time.
The redrive motor assembly
does not rotate at the specified
speed.
Possible repair actions
1. Remove all media present
in media path.
2. Check all connections on
the duplex media entrance
drive motor assembly.
3. Check all connections on
the system card assembly.
4. Replace the duplex media
entrance drive motor
assembly if problem
remains. Go to
"Duplex
drive motor assembly
removal (T652, T654)" on
page
4-10.
1. Remove all media present
in media path.
2. Ensure that upper redive
assembly is properly
installed.
3. Check all connections on
the redrive motor assembly.
4. Check all connections on
the system card assembly.
5. Replace the redrive motor
assembly if problem
remains. Go to
"Redrive
motor assembly removal
(T652, T654)" on
page
4-55.
1. Remove all media present
in media path.
2. Ensure that upper redive
assembly is properly
installed.
3. Check all connections on
the redrive motor assembly.
4. Check all connections on
the system card assembly.
5. Replace the redrive motor
assembly if problem
remains. Go to
"Redrive
motor assembly removal
(T652, T654)" on
page
4-55.
1. Remove all media present
in media path.
2. Ensure that upper redive
assembly is properly
installed.
3. Check all connections on
the redrive motor assembly.
4. Check all connections on
the system card assembly.
5. Replace the redrive motor
assembly if problem
remains. Go to
"Redrive
motor assembly removal
(T652, T654)" on
page
4-55.