Engine Setting 1 Through 16; Model Name; Configuration Id; Edge To Edge - Lexmark T650n Service Manual

Engine Setting 1 through 16

WARNING: Do not change these settings unless requested to do so by your next level of support.

Model Name

The model name can only be viewed and cannot be changed.

Configuration ID

The two configuration IDs are used to communicate information about certain areas of the printer that cannot
be determined using hardware sensors. The configuration IDs are originally set at the factory when the printer
is manufactured, however the servicer may need to reset Configuration ID 1 or Configuration ID 2 whenever
you replace the system board. The IDs consist of eight hexadecimal characters, including 0 through 9 and A
through F.
Note: When the printer detects a Configuration ID that is not defined or invalid, the following occurs:
•
The default standard model Configuration ID is used instead.
•
Configuration ID is the only function available in DIAGNOSTICS.
•
Unless the menu is in DIAGNOSTICS, Check Config ID displays.
To set the configuration ID:
1. Select Printer Setup from the Diagnostic mode.
2. Select Configuration ID from the Printer Setup menu.
Submitting Selection displays, followed by the value for Configuration ID 1.
3. Enter the Configuration ID 1.
•
To select a digit or character to change, press
•
To change a digit or character, press
•
When the last digit is changed, press
If Invalid ID appears, the entry is discarded, and the previous Configuration ID 1 is displayed on the
screen.
If the process is successful, Submitting Selection appears on the display, followed by the current
value for Confirguration ID 2.
4. Repeat the steps for entering the Configuration ID, and press
If the Configuration ID 2 is validated, Submitting Selection appears, and a check
Printer Setup.
5. Restart the printer.

Edge to Edge

When this setting is On, the text and graphics are shifted to the physical edges of the paper for all margins.
When the setting is Off, the normal margins are restored.
or until the digit or character is underlined.
to increase or to decrease the value.
to validate the Configuration ID 1.
.
4062-XXX
appears next to
3-17
Diagnostic aids