Sensor Test (Input Tray); Output Bin Tests - Lexmark T650n Service Manual

4062-XXX

Sensor Test (input tray)

This test is used to determine if the input tray sensors are working correctly. To run the Input Tray Sensor Test:
1. Select the Sensor Test from INPUT TRAY TESTS.
2. Select the input source from the sources displayed on the Sensor Test menu. All installed sources are
listed.
3. Select the sensor to test. Various sources have different combinations of sensors. See the table below:
Tray sensor support by source
Source
Tray 1
Tray 2
Tray 4
Tray 5
Multi-Purpose Feeder
Envelope feeder
[sensor selected]=OP displays.
•
Empty–Input tray empty sensor
•
Low–Input tray paper low sensor
•
passThru–Input tray pass thru sensor
4. Once this message displays, the servicer can manually actuate each sensor. The tray empty sensor can
be actuated by hand, however a sheet of paper can be used to cover the pass thru sensor. When the
sensor is closed, Closed displays; when the sensor is open, Open displays.
5. Press Back

OUTPUT BIN TESTS

Feed Tests (output bins)
Use these tests to verify that media can be fed to a specific output bin. Media is fed from the default input
source to the selected output bin. No information is printed on the media fed to the output bin because the
printhead is not engaged during this test. These tests can use any media size or envelope supported by the
printer.
Note: If the Configure Bins printer setting is Link rather than Mailbox, the printer selects its own internal bin
linking regardless of which output bin is selected for the feed test.
To run the Feed Tests for the output bins:
1. Select Feed Tests from the OUTPUT BIN TESTS.
2. Select the output bin you want the paper to exit into. The standard bin as well as any output option bin
installed on the printer is shown on the menu. (The output bins are displayed in the order installed on the
printer.)
3. Select either Single or Continuous.
•
Single–feeds one sheet of media from the selected source.
•
Continuous–media continues feeding from the selected source until Stop
3-12
Service Manual
Empty
(Input tray empty
sensor)
X
X
X
X
X
X
or Stop to exit the test.
Low
(Input tray paper low
sensor)
X
X
X
X
passThru
(Input tray pass thru
sensor)
X
X
X
X
is pressed.