Setting A Drying Feed - MIMAKI TS500-1800 Operation Manual

Setting a DRYING FEED

To dry evenly up to the back edge of the printing data, set the length to be fed after printing has been
completed. Depending to your external heater position, set it so that the data end may be fed until it passes the
external heater.
1
Press the
2
Press
3
Press the
4
Press
5
Press the
6
Press
• Set value : OFF / 100 to 1000mm
7
Press the
8
Press
backward feed after dry feed or not.
• Set value : ON/OFF
9
Press the
10
Press the
3-24
key in LOCAL.
to select [MACHINE SETUP].
key.
to select [DRYING FEED].
key.
to select the feeding length.
key.
and set whether you perform
key.
key several times to end the setting.
F UNC T I ON
S E TUP < EN T >
F UNC T I ON
MACH I NE SE T UP [ EN T ]
MACH I NE SE T UP
AU TO P o w e r - o f f [ EN T ]
MACH I NE SE T UP
DRY I NG F EED [ EN T ]
DRY I NG F EED
= 3 0 0 mm
DRY I NG F EED
= 6 0 0 mm
B ACKWARD F E ED
: ON
B ACKWARD F E ED
: OF F
MACH I NE SE T UP
DRY I NG F EED [ EN T ]