Standard Power Up Procedure - Vari Lite VL1000 User Manual

VARI LITE® - VL1000™ ERS L

Standard Power Up Procedure

Use this procedure when powering up a luminaire that has already been configured.
(Refer to
Note: Refer to
CAUTION: Before applying power, be sure the luminaire is hung or positioned so
that the head and yoke can move freely without restriction.
To power up luminaire:
Step 1. At each luminaire, apply power by switching on power source. Luminaire
26
U
UMINAIRE SER
"Power-Up and Configuration Overview" on page
Chapter 4: Menu System
will display Starting for 10-15 seconds, and then automatically step
through the following procedure:
a. For Arc lamps:
1) If Lamp Power-Up State is set to Lamp On, lamp will strike (ignite).
2) Luminaire will cycle through calibration and stop at "home" position.
3) If Lamp Power-Up State is set to Cal On, lamp will strike (ignite) at
end of calibration sequence.
b. For Incandescent lamps:
1) Luminaire will cycle through calibration and stop at "home" position.
11-Jun-02
' M
S ANUAL
for detailed instructions on menu functions.
25.)
02. 9663.0 001 B