Table of Contents
Advertisement
VARI❋LITE - VL800 EVENTWASH QUICKSTART GUIDE
Connecting Power and Data
Connecting Power
The luminaire requires standard AC power distribution from 100-240 VAC, 50/60 Hz. Current
required depends on the AC supply voltage and product model. Refer to
on page 10
for all models covered in this manual.
Note: The mating power connector is supplied; however, you will need to purchase or
construct a cable appropriate for your application.
Depending on the application, the luminaire's AC input cable may require a different
connector. If required, install a new connector meeting your requirements using the
following wire color code reference:
WARNING: DO NOT connect to three-phase service in countries with 240 volt power.
AVERTISSEMENT: NE PAS se connecter au service en trois phases dans les pays avec
puissance de 240 volts.
For single-phase power at 240 volts RMS:
For three-phase power at 200 volts RMS:
10
Figure 1: Power Connector
Wire*
Connection
Green/Yellow
AC Ground
Blue
AC Neutral
Brown
* International (Harmonized)8tandard
Connection
AC Neutral
AC Line
Ground (Earth)
Connection
Phase 1
Phase 2
Ground (Earth)
2 July 2020
Power connector
AC
ne
Li
Pin
X
Y
G
Pin
X
Y
G
"Current vs. Voltage"
Advertisement
Table of Contents
