Addressing; Program Starting Address; Program Starting Address Without Calibrating; Addressing Program Starting Address - Vari Lite VL1000 User Manual

Addressing

Program Starting Address

The DMX starting address is entered using the Menu Display. This address will be
retained even if the power is removed.
Note: Refer to
Note: Refer to your console operating instructions for specific information regarding
its addressing requirements.
To program a DMX starting address:
Step 1. Press [Menu].
Step 2. Press [Up] / [Down] arrows until Address appears. Press [Enter].
Step 3. DMX will appear. Press [Enter].
Step 4. Press [Up] / [Down] arrows to enter starting address.
Step 5. Press [Enter] to set.

Program Starting Address Without Calibrating

It is possible to bypass the calibration sequence and go directly to the Menu Display
programming in order to pre-program an address setting.
To program starting address without calibrating luminaire:
• While powering up luminaire, press and hold [Menu]. Program address as in
Program Starting Address above.
Note: The luminaire will require a reset to restore control.
02.9 663.00 01 B
Chapter 4: Menu System
11-Jun-02
I : A
NSTALLATION
for detailed instructions on menu functions.
2
DDRESSING
29