Universal Offset Support; Installation Instructions For Masonry Application - Flame Energy MONACO FL063 Installation And Operation Manual

Monaco Installation and Operation Manual
For roof support installation, refer to the instructions provided with the support by the
chimney manufacturer. Many manufacturers will provide the maximum height of chimney
that can be supported by the support. Make sure you respect those parameters.

8.8.2 Universal Offset Support

This support is used to support the chimney above an offset. When the chimney offset is
used to pass through a wall, this support may be used on the wall to support the chimney.
For offset support installation, refer to the instructions provided with the support by the
chimney manufacturer. Many manufacturers will provide the maximum height of chimney
that can be supported by the support. Make sure you respect those parameters.

8.9 Installation Instructions for Masonry Application

WARNING: BEFORE STARTING THE INSTALLATION, THE MASONRY CHIMNEY
MUST BE INSPECTED BY A QUALIFIED SWEEP.
The following requirements must be respected:
1. The chimney must be absolutely clear of any soot residue or creosote. Check for
cracks, loose or missing bricks that could inhibit correct installation of the liner.
2. The clearance to combustible must be a minimum of 1" between the outside of the
masonry and any wood framing or loose insulation.
3. The chimney must be built in accordance with the current building code.
4. No other appliance can be connected to the same chimney.
Installation:
The chimney must be relined with a stainless steel liner of the same diameter as the
outlet of the fireplace. For connection at 30
must be used to connect the liner (C) to the insulated chimney (A). Verify availability
and installation instructions for this connector with the chimney manufacturer.
66
°
or 45° angle, a special connector (B)