Table of Contents
Advertisement
Monaco Installation and Operation Manual
6.3.1.1 Raised base installation of more than 4" (R value for the hearth extension
not required)
The MONACO may be installed directly on the floor or on a raised combustible or non
combustible base. If the fireplace is elevated more than 4" (B), an R value for the hearth
extension is not required. However, the upper and lower angle, for the full width of the floor
protection, must be protected 2" horizontally and vertically (E) by a non-combustible
material. For example, a sheet metal (not included). Apart from these two corners, the
sheet metal does not have to cover the rest of the wall between the base of the fireplace
and the floor.
Note that the non-combustible hearth extension floor area must extend at least 16" (41
cm) in front of the hearth as shown in Section 6.3.2: Minimum Heart Extension
Requirements.
CLEARANCES
80" (2032 mm)
A
4" (102 mm)
B
minimum
MINIMUM
MEASUREMENTS
2" (51 mm)
E
37
Advertisement
Table of Contents
