Table of Contents
Advertisement
Monaco Installation and Operation Manual
When you burn in cycles, you rarely need to open the fireplace's loading door while the
wood is flaming. This is an advantage because there is more chance that smoke will leak
from the fireplace when the door is opened as a full fire is burning.
IF YOU MUST OPEN THE DOOR WHILE THE FUEL IS FLAMING, OPEN THE AIR
CONTROL FULLY FOR A FEW MINUTES, THEN UNLATCH AND OPEN THE DOOR
SLOWLY.
4.4.2 Ash Removal
Ash should be removed from the firebox every two or three days of full time heating. Do
not let the ash build up in the firebox because it will interfere with proper fire management.
The best time to remove ash is after an overnight fire when the fireplace is relatively cool,
but there is still some chimney draft to draw the ash dust into the fireplace and prevent it
from coming into the room.
After ashes have been removed from the fireplace and placed in a tightly covered metal
container, they should be taken outside immediately. The closed container of ashes
should be placed on a non-combustible floor or on the ground well away from all
combustible materials pending final disposal. Ashes normally contain some live charcoal
that can stay hot for several days. If the ashes are disposed of by burial in soil or otherwise
locally dispersed, they should be retained in the closed container until all cinders have
thoroughly cooled. Other waste should not be placed in this container.
NEVER STORE ASHES INDOORS OR IN A NON-METALIC CONTAINER OR ON A
WOODEN DECK.
4.4.3 Raking Charcoal
Rekindle the fire when you notice that the room temperature has fallen. You will find most
of the remaining charcoal at the back of the firebox, furthest from the door. Rake these
coals towards the door before loading. There are two reasons for this raking of the coals.
First, it concentrates them near where most of the combustion air enters the firebox and
where they can ignite the new load quickly, and second, the charcoal will not be
smothered by the new load of wood. If you were to simply spread the charcoal out, the
new load will smoulder for a long time before igniting.
Remove ash first, and then rake charcoal towards the front of the firebox before loading so
that it will ignite the new load.
21
Advertisement
Table of Contents
