FLIR F-Series Installation Manual page 17

F-Series Installation Manual
2.4 F-Series Configuration
After logging in, the Help screen is displayed. This screen has information about the camera
including hardware and software revision numbers, part numbers, and serial numbers. If you
need to contact FLIR for support, this information will be useful to the support engineer. Use
the Menu entries at the left of the screen shown in Figure 2-1 to configure the F-Series
camera.
Figure 2-1: Web Configurator Help Screen
The following paragraphs show the pages for setting serial communication parameters and
setting a new IP address for a camera on a local area network.
Serial Remote
Step 1 Click Serial Remote. The screen at
the right will be displayed.
Step 2 Enter the parameters for your serial
control configuration.
The settings you make in this screen
will only become active when the
hardware/software DIP switch is set
to allow software settings to override
the dip switch settings. Refer to
paragraph 1.13 "Setting
Configuration Dip Switches" on page
1-8.
427-0030-00-12, version 110 March 2010
2—Verify Camera Operation
2-5