FLIR F-Series Installation Manual page 11

F-Series Installation Manual
Power Board Switch Layout and Control.
numbering and on/off settings.
Switch octaves
Baud rate
Protocol
Serial Com
Preset
Hardware/Software
Not Used
Baud Rate: This is the baud rate of the system user serial port. The available values are 2400,
4800, 9600, 19200 kbaud.
Camera Control Protocol: This is the communication protocol selected for the system when
operating over the serial port. The available protocols are Pelco-D and Bosch.
Serial Communication Standard: This determines the electrical interface selected for the user
serial port. The available settings are RS422 and RS232.
Software Override of DIP Switches: This setting determines whether the system will use the
dip switches for configuration or if software settings will override the dip switch settings.
427-0030-00-12, version 110
The tables below defines the switch locations, bit
Table 1-3: Dip Switch Settings—SW102
Settings
Bit 1
OFF
ON
OFF
ON
Bit 3
OFF
ON
OFF
ON
Bit 5
OFF
ON
OFF
ON
Bit 7
OFF
ON
OFF
ON
Bit 9
OFF
ON
Bit 10
X
March 2010
1—F-Series Camera Installation
Description
Bit 2
OFF 2400
OFF 4800
ON 9600
ON 19200
Bit 4
OFF Pelco-D
OFF NA
ON Bosch
ON NA
Bit 6
OFF NA
OFF RS422
ON RS232
ON NA
Bit 8
OFF Section1
OFF Section2
ON Section3
ON Section4
Software select
Hardware select
1-9